chain tensioner

In the past, we have tried unsuccessfully to use other forms of front chain tensioners.

The 1980 Xl250 introduced few changes, however during its production the rear chain tensioner was added.

The chain tensioner should be mounted, if at all possible, directly behind the drive wheel.

And check the old-skool chain tensioner attached to the derailleur.

On most fully suspended bikes a chain tensioner (extra item) will be needed.

He'd lost his recumbent mate, whose chain tensioner had snapped off, so he was alone on this section.

This requires a sprung chain tensioner, similar to a rear derailleur, to be used.

The later 8R-G version did not receive a timing chain tensioner in an effort to make it more silent.

Until this time, the cam chain tensioner had been a manual type requiring attention from the owner on a regular basis.

The chain tension of a chainsaw may be adjusted with a chain tensioner.

The engine was affected by an oil sludge problem and premature timing chain tensioner failure, which were fixed around 2002-2004.

Many early 911 owners have had their older chain tensioners replaced with Carrera tensioners.

Automatic cam chain tensioner for low maintenance.

An unscheduled stop was required to free Kirsty's scarf from the chain tensioner on their new tandem.

One mechanical change on this and subsequent models was the introduction of an "automatic" cam chain tensioner and associated bits.

The C3 also got the new "automatic" cam chain tensioner and the rubber mounted footrests mentioned in the B3 writeup.

However, this does require a chain tensioner of some sort, negating some of the advantages of hub gears.

APE billet manual cam chain tensioner.

On bicycles with vertical dropouts, a chain tensioner is often required to allow the correct tension on the resulting shorter chain.

Describe purpose and function of chain tensioners, and perform basic installation / adjusting procedures with fitted tensioners.

Sometimes the rear-derailleurs are re-purposed as chain tensioners for single-speed bicycles that cannot adjust chain tension by a different method.

When fitted to a rear suspension bike, it also retains a derailleur-like jockey cage chain tensioner, although without the derailleur's low ground clearance.

Only relatively uncommon frame designs with single pivots that are concentric with the bottom bracket allow the use of more desirable static chain tensioners.

Due to a communication error with the frame builder, my frame ended up with standard vertical dropouts necessitating the use of the chain tensioner.

The brake discs were increased in size to aid in more effective heat dissipation and improved oil-fed chain tensioners were fitted to the engine.