corner radius

Corner radius of punch should be 4-10 times the sheet thickness.

The main body of the chamber has then been extracted and corner radii added.

Allow the maximum possible corner radius for label recesses.

The wire diameter needs to be less than double the minimum internal corner radius for successful machining.

If the die corner radius is small than wrinkling near the flange region becomes more prominent.

Too small die corner radius results in cracks due to sharp change in the direction of metal flow.

The minimum internal corner radius of the feature will dictate the maximum wire diameter that can be used.

The idea isn't to remove a lane of traffic, but to tighten the corner radius of the intersection.

Factors such as height of the maneuver bottoms, shapes, corner radius, and other factors are considered.

Conversely, accelerating while turning increases the motorcycles cornering radius.

All corner radii are assumed equal.

Third, decreasing speed decreases the motorcycle's cornering radius.

Small concave corner radii are difficult to be completely calibrated, i.e. filled, because too large a pressure would be required.

Safari on iOS has set the corner radius of radio buttons to a fixed number of pixels.

In advanced mode, corner radius and feathering adjustments can be made and feedback as to height and width or mask is provided.

Paper Drying cylinder deficiency Paper Drying steam pressure vessel - section through bore to flange corner radius.

(ii) A minor deviation in corner radius profile at the inner end of the bore of the yoke, with a small increase in the attendant stress concentration.

The clearance area is a rounded rectangle whose sides extends at least 8.5 mm beyond the hole centers and with a corner radius of at most 7 mm.

Other important requirements concern transportation (a reasonable transit speed is needed), damage to road surfaces (especially with tracked vehicles), road and bridge capacity, and transporter ground clearances and cornering radius.

Inverting the lugs allows greater clearance on a shaft or in a housing and forms a higher uniform shoulder good for retaining bearings and other components with large corner radii or chamfers.

First, the port name, the number of ports, the port angular, arc and chord widths, the port height and for non profiled ports the top and bottom corner radii are displayed.

There is also a term bull nose cutter, which refers to a cutter having a corner radius that is fairly large, although less than the spherical radius (half the cutter diameter) of a ball mill; for example, a 20-mm diameter cutter with a 2-mm radius corner.