input power

"I can't increase the input power to the time cell."

The work, performed during the expansion, is used to reduce the total input power.

Input power is only useful when comparing lights of similar technologies.

Now look at the case of the refrigerator and assume that the input power is zero.

Due to the low absorption very high field strength can be achieved with moderate input power.

They produce perhaps 15 lumens per watt of input power.

Ideally, input power would be divided equally between the output ports.

Work done by the expanding fluid cools it and is available to replace some of the input power.

Sometimes the curve is nonlinear, typically with lower slope at high input powers.

For this reason, the instantaneous input power and the output power are equal.

If a mechanical system has no losses then the input power must equal the output power.

Energy recovery systems harvest the output power and providing this as input power to the same or another process.

The extra input power is dissipated as heat.

With max input power handling of 500mW, these over-the-head headphones save on your battery too.

The rated input power does not indicate the effectiveness of the cleaner, only how much electricity it consumes.

The calculated power leaving the cell was significantly higher than the input power during these high temperature phases.

In certain applications, compressed air, or other gas, can be used for Mud Motor input power.

Two basic varieties distinguished by the type of input power are common: single-phase and three-phase.

The calorimeters were calibrated to an accuracy of 0.02% of input power.

By cascading, the input power might be divided to any -number of outputs.

I don't understand that one, because we know that any kind of input power will be re-beamed as similar power.

The input power efficiency is then enhanced.

Loss in motor efficiency is determined by the difference between the input power and output or shaft power.

It means jacking up the input power to the rig-putting a greater and greater stress on his brain.

Energy lost in magnetic ballasts was around 10% of lamp input power according to GE literature from 1978.