overtighten

Do not overtighten but make sure the screws are tight.

Do not overtighten these nuts or you could crack the bowl.

Do not overtighten the screws as they are in end grain.

Then tighten the nut down over it, but do not overtighten.

It is important not to overtighten screws as this will reduce the holding strength.

Be careful not to overtighten the clamp or you could damage the wire.

Once again, do not overtighten at this stage.

Do not overtighten, otherwise the shields may pull loose.

Care should be taken not to overtighten screws.

Sure enough, roughly 90 seconds later, I overtighten the first gas jet and it shears off in my hand.

Again, don't overtighten the bolts at this stage.

Do not overtighten as this prevents expansion and contraction of the Thermoclear.

Care has to be taken not to overtighten fasteners, but using power tools is easier and requires far less strength than driving by hand.

Ensure that these screws are tight but do not overtighten as you may damage the rod alignment.

Do not overtighten or exceed three threads clear on the nuts (use extra washers).

Follow proper torque recommendations; do not overtighten wheel nuts or bolts.

Don't overtighten the filter, about V, - % of a turn after the seal contacts the block.

Do not overtighten the fixing bolt (not supplied) as this could damage the winding.

Fit replacement olives and reconnect the fitting with two spanners, but do not overtighten.

Reinstall the drain plug, but do not overtighten it, and refill the engine with fresh oil.

Do not overtighten the cap. 12.

Be careful that you do not overtighten, since it only requires a modest amout of torque to seal.

Tighten the coupling to compress the washer; don't overtighten.